Vertex Dickinson Concrete

Concrete floor installation in Dickinson ND - a hard surface on solid ground

Broad tiled concrete steps rise to a landscaped patio and covered porch surrounded by lush plants.
  • Licensed and insured.
  • Free on-site estimates.
  • We reply within 1 business day.

Who installs concrete floors in Dickinson, ND?

Vertex Dickinson Concrete does concrete floor installation in Dickinson, and we start with the ground under the slab before anything else. Then we pour, finish, cut joints and cure the concrete at the right moments. I come out to look at the job, and our own crew does the work with me there running it.

Most folks call about a floor for a shop, a basement or an addition, or to replace one that's cracked and uneven. The job is a slab placed on the subgrade, the ground it all sits on, and the base we pack over it, then finished, jointed and cured. What's under the slab matters more than any steel inside it, because poor ground lets a floor fail anyway.

Price mostly follows the size of the floor and how much work the ground needs. The schedule follows the weather and curing, which is the wait while the concrete hardens enough to take weight. When I come out to look, I'll tell you what your ground needs and give you the estimate for your floor.

On an indoor floor the finishing, jointing and curing each have to happen at the right moment, so we plan the whole day around those steps instead of rushing them. It's the same care we put into concrete pool decks and new concrete steps around Dickinson, where the work nobody sees decides how the job holds up.

What a floor job takes

  • Digging out and packing the base
  • Vapor barrier where moisture matters
  • Finishing timed to the concrete
  • Control joints cut on time
  • Curing before the floor takes weight
  • Cold-weather protection for winter pours

Before you book concrete floor installation

  • What shapes the cost

    Past the floor's size and ground work, the price moves with whether an old floor has to come out, how easy the space is to reach and the finish you pick.

  • What decides the pour day

    Every step from finishing to curing runs on the concrete's clock, so we set the day by the weather and the space, and a cold pour adds protection and heat.

  • Spend on the base first

    If the budget gets tight, I'd cut back on the finish before the base, because nobody sees the ground on pour day, but it's what decides how the floor holds up.

Concrete floor questions from Dickinson

  • Will my new concrete floor crack?

    Probably a little, because even a well-built floor won't stay completely free of cracks and curling. We cut control joints, lines in the slab that give it a spot to crack where we chose instead of wherever it likes, and if a floor gets wire mesh, the mesh won't stop cracking but tends to keep cracks and joints from opening up. A good base and good timing are what keep cracking small and tidy.

  • How much does concrete floor installation cost in Dickinson?

    There's no set price for a concrete floor, because the size, the ground work and the finish change from one space to the next. I come out, look at the ground and the space, and give you a number for your floor. Call (701) 495-9954 to set that up.

  • Can concrete floors be poured during a Dickinson winter?

    Yes, concrete placed when the air is at or heading below 40°F still gains enough strength when it's mixed, placed and protected properly. The colder it gets, the more protection it needs, so a winter floor means extra work on site to look after the fresh concrete while it cures.

  • What causes a dusty concrete floor?

    A dusty top usually comes from bad timing, because finishing, jointing and curing done at the wrong moment can leave a floor that dusts, wears fast or has high and low spots. Exhaust matters too, since carbon monoxide from heaters and engines can dust a surface that's less than 24 hours old. When we're heating a space for a cold pour, we watch what's running near the new floor.

  • Do I need a building permit for a new concrete floor in Dickinson?

    You might, because the City of Dickinson handles building permits for Stark County and requires one before you build or significantly renovate a structure. City code enforcement checks that construction follows the city's building code, and you can reach building inspection at 701-456-7035, option 1. We check with the city on every job before we start, take care of the permits that fall to us and help you with any that fall to you.

  • How do I check if a concrete contractor is licensed in North Dakota?

    Search the North Dakota Secretary of State's list of registered contractors to see whether a license is in good standing. The state requires whoever does a job costing more than $4,000 to be licensed as a contractor, so it's worth a look before you sign. We're licensed and insured.

Concrete floors near you

We're based in Dickinson and pour floors there and in the cities around it, so pick your area below or call (701) 495-9954 if yours isn't listed.

Ask for a free concrete floor estimate

Tell us the floor's size, what it's for and when you'd like it done. We reply within one business day, then I come out to look, with no pressure to book.

(701) 495-9954